Sunrans Outdoor SPAS Hot Tub For Sale Supplier

                     1)this is Acrylic.it is broken .make clean  surface of Acrylic 2) Use resin full the broken part.                           3) Whe the resin dry ,use sand paper to polish it              4) choose  the same color of paint, Painting on the fix place .                                            5)after paint ,the color is ok . 6) When the paint is dry ,use sand paper to polish it again ,pls be careful .at last put some Polishing solution on this place ,use d ishrag to clean it.                                           At last ,the spa ...

When you open the system box ,you can find the Voltage is 220V and contace lead like pictures:                     2) find out the black lead ,which I sign out it in red color: 3)take off these two leads                       4) now you will find two black leads ,same like pictures: 5) take out the one sides of these two leads ,which I sign out by red color.              6)Contact these two sides into new code place.such as pictures                  7)then your system is for 380V ,3 phase,same like pictures

1)     Take off cabinet first, find the Air blower. 2)you can find there are two Spiral interfaces, open them, then you can skate away the pipe (white pipe) 3)When you open this Spiral interface, you will find one spring inside it. 4)this is spring wire. 5)Pls check the under base of spring wire, whether is it contact with base by glue.the correct way: it should not be contact.,if contact, pls take them separately. 6)then Stretching the spring wire.near 2-3CM .make it long egough.put back again . 7)after that put pricing wire back again 8)at last, contact the pipe again with Air blower, the Air can ran from Air jet.

Steps: 1.Open the control box, find out these two short wires(white and blue), take out of them. 2.Connect the firing line(3pcs),zero line(1pc),ground line(1pc). 3.Put this black line(see follow picture) from J25 to J28.

Testing 1： 1) Please CLOSE the 2pcs “Hand draw Valve“ at the two sides of the circulation pump. 2) Then turn on the heater 5 seconds. 3) Turn off the heater 4) Drip a little water on the heater to see whether there is steam come out from the heater. Testing 2: To check whether there is solid state（like leaf, paper towel in the pipe which connected to the heater. ） We have tested if the water flow rate is too low, the heater won’t work but the Indicate light still on which shows it is working. Testing 3: 1) Please take out the paper element filter 2) Then turn on the heater to see whether it is heating the water actually. (If the weather is too cold, need to be compared a long time to rise 1degree. (we have made the test below： SPA SR826 Heater: 3KW outdoor temperature: 19 degree Heating with cover 35minutes rise 1 degree